All About Plumbing Gazette Today

Handy DIY Plumbing Tips For The Homeowner

Feb 3

 

Did you know that faulty air chambers might be why you are hearing a hammering sound in your pipes? The noise is known as water hammer and it may mean that water has entered your air chamber. Here are some tips to help you fix your problem.

Plumbing Giant

If your pipes bang when you turn on the water, and all the pipes are anchored correctly, you should add some straps or cushion the pipes with a rubber blanket. There may be times when you will need to do both. Make sure that if you have copper pipes, you are not using galvanized straps.

If a pipe ever freezes, you need to make sure to shut off the water. This will keep the pipe from bursting and causing you major damage to your home. Make sure to shut the water off at the main valve, and then open the faucet that is closest to the frozen pipe so it can drain while it is thawing out.

In order to prevent any pipes within your home from freezing, you should never let the home temperature get below freezing. Always insulate pipes exposed to elements. If the temperature surrounding the pipes is anywhere below freezing, this can cause the pipes to freeze. Even in the best case scenario, it will take hours for thawing to happen before you have running water again. However, frozen pipes often burst, causing damage to your home and a hefty repair bill.

Make sure you know where your home's water shutoff is located. You never know when there might be an emergency involving a broken pipe or damaged connection that requires you to turn off the water right away. In addition, knowing where the shutoff is located is vital before you start any plumbing project, in case anything goes wrong.

Don't pay a plumber until the job is completed. A plumber may require some money upfront, but it's wise to wait until the job is completely done before giving him the entire payment. Many things can happen between the stop and end of a job, so to be safe wait until you are satisfied with the completed work before paying.

Check your faucets for leaks. Check the knobs and the faucet itself. Hundreds of gallons of water a day can be wasted due to leaks and that's not good if you're paying your water bill. By stopping a leak now, you can save yourself a lot of money. Leaks can grow over time as well, so avoid a disaster and check all faucets for leaks!

Many people deal with clogged toilets. However, if your toilet will not flush every time, the water rises to the top, and there is bubbling effect occasionally, this can be due to a much deeper blockage in the main pipe. The main pipe must then be cleaned in order for your toilet to work properly.

Use enzyme based cleaners when cleaning clogged pipes. These cleaners employ helpful bacteria which process the sludge lining your pipes, and turn it to liquid. The enzyme cleaners are the best on the market.

Have your pipes in your plumbing system frozen? You can skip the cost of hiring a plumber by using this method. First, open the faucet so steam produced by the thawing process can escape. Begin thawing close to the faucet, and move down the line as each section thaws out. Use a hair dryer or a heat lamp to warm along the pipe. Even though this method consumes quite a bit of time, it is safer than most other heating methods. Furthermore, it requires no cleanup.

Regular maintenance of your plumbing lines is a great idea. Your options are getting your lines snaked or jetted. Jetted is a technology that is proven more effective than snaking is. It gets deeper and cleans harder. So jetting is a good idea next time you are having maintenance performed on your lines.

Make sure that the temperature of your home's water heater is not above 120F. On older water heaters, be sure it is not above medium settings. When temperatures get higher than 120, scalding can occur. Also, having the settings above 120F, tends to use more energy than lower temperatures do.

If you have an underground leak in your pipes, it is possible to detect the leak before digging. Today's leak detection equipment is very sophisticated and modern, allowing technicians to detect and pinpoint exactly where leaks are before they go about trying to fix them with professional grade equipment for you.

You know what can cause that hammering noise, plus a lot more plumbing information. You just saved yourself a lot of money if any of those issues became unbearable or resulted in broken parts. Take time to read back over this article periodically to make sure that you are on top of your plumbing skills.

Plumbing Giant